Customer Service 1-888-707-1880 Dyaco Canada Inc. 2013
Email: customerservice@dyaco.ca
9
STEP 4: CONSOLE AND PLASTIC PARTS ASSEMBLY
1. Insert the Computer Cable (29) and Hand pulse Wires (26) into the connectors in the
back of the Console (34).
2. Install the Console (34) onto the Console Mast (2) with the 4pcs of M5 x 12mm
Phillips Head Screw (58) by using the Phillips Head Screw Driver (93).
3. Install the Front Stabilizer Cover (40) and the Rear Stabilizer Cover (41) onto the Main
Frame (1) with the 4pcs of M5 x 12mm Phillips Head Screws (58) by using the Phillips
Head Screw Driver (93).
4. Install the Pedals (45L, 46R) onto the Cranks by using 13/15mm Wrench (92).
Remember that the left pedal has a reverse thread and will be screwed into the crank
in the opposite rotation from normal threads. There is an “L” stamped into the end of
the threaded post of the left pedal and an “R” in the right. Make sure to tighten the
pedals as much as you possibly can. It may be necessary to re-tighten the pedals if
you feel a thumping during pedaling the bike. A noise or feeling such as a thumping or
clicking is usually caused by the pedals being too loose.
5. Install the Seat mount slide (7) (post at the front) onto the track on top of the seat
bracket (6) by sliding a Flat Washer (71) onto the seat adjustment knob (86), then
slide it through the slots of each and attach a flange nut (8) to the end. Install the seat
(19) onto the seat post by securely tightening the nut on each the side, below the
seat.
6. Install the Drink Bottle Holder (116) onto the Console Mast (2) with the 2pcs of Phillips
Head Screws (58).Tighten using the Phillips Head Screw Driver (93).
HARDWARE
#58.
M5 × 12mm
Phillips Head Screw (10 pcs)
