Customer Service 1-888-707-1880 Dyaco Canada Inc. 2013
Email: customerservice@dyaco.ca
23
How to wear your wireless chest strap transmitter:
1. Attach the transmitter to the elastic strap using the locking parts.
2. Adjust the strap as tightly as possible as long as the strap is not
too tight to remain comfortable.
3. Position the transmitter with the logo centered in the middle of
your body facing away from your chest (some people must
position the transmitter slightly left of center). Attach the final end
of the elastic strap by inserting the round end and, using the
locking parts, secure the transmitter and strap around your chest.
4. Position the transmitter immediately below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals. However,
plain water can also be used to pre-wet the electrodes (2 black square areas on the
reverse side of the belt and either side of transmitter). It’s also recommended that you
wear the transmitter strap a few minutes before your work out. Some users, because of
body chemistry, have a more difficult time in achieving a strong, steady signal at the
beginning. After “warming up”, this problem lessens. As noted, wearing clothing over the
transmitter/strap doesn’t affect performance.
6. Your workout must be within range - distance between transmitter/receiver – to achieve a
strong steady signal. The length of range may vary somewhat but generally stay close
enough to the console to maintain good, strong, reliable readings. Wearing the transmitter
immediately against bare skin assures you of proper operation. If you wish, you may wear
the transmitter over a shirt. To do so, moisten the areas of the shirt that the electrodes will
rest upon.
Note: The transmitter is automatically activated when it detects activity from the user’s heart. Additionally, it
automatically deactivates when it does not receive any activity. Although the transmitter is water resistant,
moisture can have the effect of creating false signals, so you should take precautions to completely dry the
transmitter after use to prolong battery life (estimated transmitter battery life is 2500 hours). The replacement
battery is Panasonic CR2032.
Erratic Operation:
Caution!
Do not use this bike for Heart Rate Control unless a steady, solid Actual
Heart Rate value is being displayed. High, wild, random numbers being displayed
indicate a problem.
Areas to look at for interference, which may cause erratic heart rate:
(1) Microwave ovens, TVs, small appliances, etc.
(2) Fluorescent lights.
(3) Some household security systems.
(4) Perimeter fence for a pet.
(5) Some people have problems with the transmitter picking up a signal from their skin. If you
have problems try wearing the transmitter upside down. Normally the transmitter will be
oriented so the logo is right side up.
(6) The antenna that picks up your heart rate is very sensitive. If there is an outside noise
source, turning the whole machine 90 degrees may de-tune the interference.
(7) Another Individual wearing a transmitter within 3’ of your machine’s console.
If you continue to experience problems contact your dealer.
Using a Heart Rate Transmitter
