Customer Service 1-888-707-1880 Dyaco Canada Inc. 2013
Email: customerservice@dyaco.ca
8
STEP 3: HANDLE BAR ASSEMBLY
1. Run the two hand pulse wires (26) into the hole in the handle bar mounting plate and
out through the hole in the console plate. Remove the black plastic cover from the
handlebars by cutting the plastic tie.
2. Install the Handle Bar (3) onto the Console Mast (2) with the 2pcs of Hex Head Bolts
(51), 2pcs of Flat Washers (72), and 2pcs of Split Washers (103), being careful not to
pinch the hand pulse wires. Tighten using the Wrench (100). Snap the black plastic
handlebar cover over the joint.
HARDWARE
#72.
5/16” × 18 × 1.5T
Flat Washer (2 pcs)
#51.
5/16” × 5/8”
Hex Head Bolt (2 pcs)
#103.
5/16” × 1.5T
Split Washer (2 pcs)
