Customer Service 1-888-707-1880
Dyaco Canada Inc. 2014
Email:
customerservice@dyaco.ca
23
Custom User Defined Programs
There are two customizable User programs that allow you to build and save your own
workout. The two programs,
User 1
and
User 2
, operate exactly the same way so there is
no reason to describe them separately. You can build your own custom program by
following the instructions below or you can save any other preset program you complete
as a custom program. Both programs allow you to further personalize it by adding your
name.
1.
Press the
User 1
or
User 2
key. The Message Center will show a welcome message.
If you had previously saved a program the message will contain your name. Then
press the
Enter
key to begin programming.
2.
When you press
Enter
, the Message Center will show “Name - A”, if there is no name
saved. If the name “David” had been previously saved the Message Center will show
“Name - David” and the D will be blinking. If there is a name saved you can change it
or you may press the
Stop
key to keep the name and continue to the next step. If you
want to enter a name use the
Up
/
Down
key to change the first letter then press
Enter
to save the first letter and continue to the next letter. When you have finished entering
the name press the
Stop
key to save the name and continue to the next step.
3.
The Message Center will ask you to enter your Age. You may enter your age, using
the
Level Up
/
Down
keys, then press the
Enter
key to accept the new value and
proceed on to the next screen.
4.
You are now asked to enter your Weight. You may adjust the weight value using the
Up
/
Down
keys or the numeric key pad, then press
Enter
to continue.
5.
Next is Time. You may adjust the time and press
Enter
to continue.
6.
Now you are asked to adjust the Max Resistance Level of the program, press
Enter
when resistance has been selected.
7.
Now the first column will be blinking and you are asked to adjust the resistance level
for the first segment (SEGMENT > 1) of the workout by using the
Level Up
key. When
you finish adjusting the first segment, or if you don’t want to change, then press
Enter
to continue to the next segment.
8.
The next segment will show the same workload resistance level as the previously
adjusted segment. Repeat the same process as the last segment then press
Enter
.
Continue this process until all twenty segments have been set.
9.
The Message Center will then tell you to press
Enter
to save the program. After
saving the program the Message Center says “New program saved” then will give you
the option to star t or modify the program. Pressing
Stop
will exit to the star t up
screen.
