Customer Service 1-888-707-1880
Dyaco Canada Inc. 2020
Email: customerservice@dyaco.ca
22
FITNESS TEST PROGRAMMING
1. Using the Program button choose Fitness Test and press Enter.
2. The Dot Matrix Message Center will display Gender. Use the Up and Down arrows if you
need to change, then press Enter. The choice of gender determines which workload
chart will be used for the test.
3. The Dot Matrix Message Center will ask you to enter your Age. You may adjust the age
setting, using the Up and Down buttons then press the Enter button to accept the new
number and proceed on to the next screen.
4. You are now asked to enter your Weight. You may adjust the weight number using the Up
and Down buttons then press Enter to continue.
5. Now press Start to begin the test.
Before the test:
Make sure you are in good health; check with your physician before performing any exercise if
you are over the age of 35 or persons with pre-existing health conditions.
Make sure you have warmed up and stretched before taking the test.
Do not take in caffeine before the test.
Hold the hand grips gently, do not tense up.
During the test:
The console must be receiving a steady heart rate for the test to begin. You may use the hand
pulse sensors or wear a heart rate chest strap transmitter.
You must maintain a steady 50 RPM pedal speed. If your pedal speed drops below 48 RPM or
goes above 52 RPM the console will emit a steady beeping sound until you are within this range.
You may scroll through the various data readings in the LED Data Display Windows by pressing
the Up/Down Scan button next to the LED Data Display Windows.
The LED Data Display Windows will always display your pedal speed on the right side to help
you maintain 50RPM.
The data shown during the test is:
a.
Work
in
KGM
is actually an abbreviated form of kg-m/min. which is a work
measurement of kilogram-force meter/minute
b.
Work
in
Watts
(1 watt is equal to 6.11829727787 kg-m/min.)
c.
HR
is your actual heart rate;
TGT
is the target heart rate to reach to end the test.
d.
Time
is the total elapsed time of the test.
After the test:
Cool down for about one to three minutes.
Take note of your score because the console will automatically return to the start-up mode after
a few minutes.
