S
S
e
e
r
r
v
v
i
i
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
1
1
7
7
LED has problem that would be not
bright, incomplete or imperfect.
1. LED light was broken.
1.Replace LED or console.
Seven segment displays have problem
that would be not bright, incomplete
or imperfect.
1. Seven segment displays was broken.
1.Replace console and calibrate it.
When press “START” button to start
treadmill, running belt isn’t running
and window displays “LS” error
message after 8 seconds.
1. Controller has unusual with shut down, the S_D
light will be always bright.
2. Motor wires (red, black) didn’t plug into
controller.
3. Computer cables don’t connect on right position.
4. Computer cables were broken that got damage.
5. Motor belt was cut off.
6. Controller was broken.
7. Motor was broken.
8. Console was broken.
1.Turn off power and reset the treadmill.
2.Plug wires again.
3.Plug the wire again on controller,
connector and console.
4. Replace the wires.
5.Replace motor belt.
6.Replace controller.
7.Replace motor.
8.Replace console.
When press “START” button to start
treadmill, running belt is running but
window displays “LS” error message
after 8 seconds.
*Speed sensor cable was
1. The distance is too long between speed sensor
cable and magnet.
2. Don’t have magnet or magnet fall off.
3. Magnet doesn’t have magnetic.
4. Speed sensor cable was broken.(short)
1.Adjust the distance to 5mm between
speed sensor cable and magnet.
2.Replace a magnet.
3.Use metal material to test the magnet if
have magnetic.
4.Replace sensor cable.
