7
Dyaco
Canada
Inc.
2018
customerservice@dyaco.ca
IMPORTANT OPERATION INSTRUCTIONS
●
NEVER
operate this treadmill without reading and completely understanding the results of any
operational change you request from the computer console.
●
Understand that changes in speed and incline do not occur immediately. Set your desired
speed on the computer console and release the adjustment key. The computer will obey the
command gradually.
●
NEVER
use your treadmill during an electrical storm. Surges may occur that could damage
treadmill components.
●
Use caution while participating in other activities while walking on your treadmill; such as
watching television, reading, etc. These distractions may cause you to lose balance or stray
from walking in the center of the belt; which may result in serious injury.
●
NEVER
mount or dismount the treadmill while the belt is moving. Treadmills start with at a very
low speed and it is unnecessary to straddle the belt during start up. Simply standing on the belt
during slow acceleration is proper after you have learned to operate the unit.
●
Always hold on to a handrail or hand bar while making control changes (incline, speed, etc.).
●
Do not use excessive pressure on console control keys. They are precision set to function
properly with little finger pressure. Pushing harder is not going to make the unit go faster or
slower. If you feel the buttons are not functioning properly with normal pressure contact your
dealer.
SAFTY TETHER CORD
A safety tether cord is provided with this unit. It is a simple magnetic design that should be
used at all times. It is for your safety should you fall or move too far back on the tread-belt.
Pulling this safety tether cord will stop tread-belt movement.
To Use:
1. Place the magnet into position on the console control head. Your treadmill will not start
and operate without this.
2. Fasten the plastic clip onto your clothing securely to assure good holding power.
Note:
The
magnet has strong enough power to minimize accidental, unexpected stopping. The clip
should be attached securely to make certain it does not come off. Be familiar with its function
and limitations. The treadmill will stop, depending on speed, with a one to two step coast
anytime the magnet is pulled off the console. Use the red Stop / Pause switch in normal
operation.
