6
5. The flywheel does not revolve while pedaling
1. Check if the belt breaks. (Replace the belt following step 4 if it is broken.)
Refer to 1-3 for checking procedure.
Figure 5-1-1 Left side belt Figure 5-1-2 Right side belt
Troubleshooting Procedures
Step 1
:
:
:
:
Refer to step 1-3 to remove left and right chain covers and check if the C-ring, at the left side of
flywheel axle, is in the notch and stay immediately next to the bearing, as shown in figure A-1. If not,
push the C-ring to the bearing to the end. Then check if the positioning post, at left side of the flywheel
axle, is tight and immediately next to the bearing, as shown in figure A-2. If not, push the positioning
post to the bearing to the end. If both C-ring and the positioning post are in correct position, check if
left and right chain covers are deformed so that the interactions are caused. Replace deformed chain
cover and resume all parts.
Figure A-1 Figure A-2
Summary of Contents for SE500
Page 1: ...SERVICE MANUAL SE500 ...