XE100 / XE200 / XE300 Elliptical
22
Getting familiar with the control panel
■
XE100 & XE200
Console
Power up
The Elliptical is supplied with an external power supply. When power is connected to the Elliptical,
the console will automatically power up. If there is no input to the console for 20 minutes the
console will go to stand-by mode. In stand-by mode the console display will turn off. To turn the
console on press any key.
When initially powered on the console will perform an internal self test. During this time all the
lights will turn on. When the lights go off the dot matrix display will show a software version (i.e.:
VER 1.0) and the message window will display an odometer reading. The odometer reading
displays how many hours the elliptical has been used and how many virtual miles the elliptical has
gone. The display will look like this: ODO 123 MI 123 HRS.
The odometer will remain displayed for only a few seconds then the console will go to the start up
display. The dot matrix display will be scrolling through the different profiles of the programs and
the message window will be scrolling the start up message. You may now begin to use the
console.
Operation of Your Elliptical
