XE100 / XE200 / XE300 Elliptical
34
Getting familiar with the control panel
XE300 Console
Power up
The XE Series Elliptical is supplied with an external power supply. When power is connected to
the XE Series Elliptical, the console will automatically power up. If there is no input to the console
for 20 minutes the console will go to stand-by mode. In stand-by mode the console display will
turn off. To turn the console on press any key
When initially powered on the console will perform an internal self-test. During this time all the
lights will turn on. When the lights go off the dot matrix display will show a software version (ie:
VER 1.0) and the message window will display an odometer reading. The odometer reading
displays how many hours the elliptical has been used and how many virtual miles the elliptical has
gone. The display will look like this: ODO 123 MI 123 HRS.
The odometer will remain displayed for only a few seconds then the console will go to the start up
display. The dot matrix display will be scrolling through the different profiles of the programs and
the message window will be scrolling the start up message. You may now begin to use the
console.
