XE Series Elliptical
8
UNPACKING THE UNIT
1. Using a razor knife (Box Cutter) cut the outside, bottom, edge of box along the dotted Line. Lift Box
over the unit and unpack.
2. Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged parts
are found, or parts are missing, contact your dealer immediately.
3. Locate the hardware package. The hardware is separated into four steps. Remove the tools first.
Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions
that are in parenthesis (#) are the item number from the assembly drawing, for reference.
STEP 1: REAR RAIL ASSEMBLY
1.
Remove the hardware from the hardware pack for step 1. You should have four 3/8 x
3-3/4 bolts (77), four curved washers (104), two 3/8 x 2-1/4 bolts (75), two flat
washers (96) and two M5 X 12m/m Phillips head screws (84).
2.
Put the two flat washers (96) on the 2-1/4 bolts (75) and install them through the two
holes in the top of the middle stabilizer tube and hand tighten into the rear rail assembly
(2).
3.
Put the four curved washers (104) on the 3-3/4 bolts (77) and hand-tighten them
through the front of the middle stabilizer tube, into the rear rail assembly.
4.
Using the wrench provided tighten all six bolts securely.
5.
Install the front stabilizer cover (59) with the two M5 X 12mm screws (84).
Assembly Instructions
Summary of Contents for XE 850
Page 11: ...XE Series Elliptical 10...
