6
Elliptical
Trainer
XE
295
1. Slide two Wave Washers (
81
) onto both the Left and Right Console Mast axle.
2. Slide the Swing Arms (L) and (R), (
10
&
11
) onto the appropriate side of the axle.
Note: Make sure the arms are
attached as shown in the illustration.
3. Place a Flat Washer (
97
) onto each Hex Head Bolt (
103
) and fasten in the end of the left and right axle.
Tighten with the wrench (
106
).
4. Slide the grommet (
123
) onto the Resistance cable (
124
); connect the two Resistance cables (
124
&
125
)
and store the excess cable in the Console Mast tube (
12
) after snapping the grommet into the hole of the
console mast tube.
HARDWARE
STEP 2:
Swing Arms
#97.
3/8” x 30mm
Flat Washer
(2 pcs)
#81.
25mm
Wave Washer
(4 pcs)
#103.
3/8” x 3/4”
Hex Head Bolt
(2 pcs)
#123.
Grommet
(1 pc)