10
8. Have one person stand inside of the pool liner and lift the white membrane top rail (with the Top
Structure (A) inside). Arrange the protruding Top Structure ends to fit down into the nearest
vertical Upright Structure Tube (C). The person inside the pool should continue lifting the
adjacent Top Rail Membrane, as the outside person inserts each successive Top Structure end
down into the vertical Upright Structure Tube, until the Pool liner is completely attached to the
Vertical Supports. At this point, your Titan3 Round Pool is self-standing.
9. Open the bag of Clear Elastic PVC hose (D), and Connecting Pins (E). Distribute one of each at
every Upright Structure Tube around the pool. First insert Connection Pin (E) into one end of the
Hose. Thread the Hose through the attachment sleeve which is welded to the bottom side of the
liner, just behind the base of the Upright Structure Tube. Pull the PVC Tube until there is an
equal amount on each side. Holding the tubes together, thread them from the back to the front
between the Bottom Base Tubes (B), then separate the tubes and wrap each back around both
sides of the Bottom Tube/ Upright Structure, and attach together using the Connecting Pin.
Check to insure that most of the floor wrinkles are removed. This may require occasionally
pulling on the Elastic Hose during initial water fill to take out the wrinkles in the floor. After the
pool Is full of water, you may remove the Elastic Hose and store for future use.
10. Follow the ladder set up instructions and be sure to securely attach to the Titan3 Pool.
Summary of Contents for TitanPool3
Page 1: ...By Owner s Guide...