9
Titan3 Round Pool Assembly Instructions
1.
Survey your yard to determine the best, level location for your Pool. Remember do not install
under Power Lines. Local a level area approximately two (2) ft in diameter larger than your pool,
to allow enough space for the legs. Also, make certain that the area has easy access to an
appropriate GFI Protected Outdooor electrical outlet.
2.
Remove all rocks, sticks and any other sharp objects from the area where the pool will be
installed.
3.
Your Titan3 Pool will stand about 49” tall, when filled with water. Some localities do not require
the homeowner to obtain any permits or to install a fence, if the pool wall height is 48” high or
higher. However, it is the homeowner’s responsibility to meet all applicable safety/health codes
and zoning regulations.
4.
Unfold the Pool Liner and locate the reinforced holes closest to the GFI Outdoors Electrical
outlet.
5.
Remove the metal structural parts from their boxes and place them around the outside of the
pool, making certain the top and bottom structure tubes (A & B) are arranged together. Also
place one (1) Upright Structure Tube (C) with every set of top and bottom tubes.
6.
Slide the Top Structure (A) thru a slot opening in the white top rail membrane. Note that the
other end of the top structure should protrude from the next opening in the top rail membrane.
Install a second Top Structure (A) through the same opening that the previous end protrudes,
and slide it to the next opening. Continue inserting the Top Structure Pieces around the entire
pool top rail membrane.
7.
Slide an Upright Structure Tube (C) onto the upright end of a Bottom Structure (B). Have a
helper hold this Upright Tube in a vertical position. Continue around the pool until all Bottom
Structures (B) are attached with the Upright Tubes (C). The Upright Tubes and Bottom
Structures are, now, self standing. (
Remember to disregard the color of the structure
)
Summary of Contents for TitanPool3
Page 1: ...By Owner s Guide...
