EXHAUSTING
The appliance should not be exhausted into a chimney, wall,
ceiling, or any concealed space of a building. Only rigid or flex
metal/metallic duct should be used for exhausting, unless the
appliance has been investigated for use with non-metal/metallic
duct (See Fig. 7).
To prevent large amounts of lint and moisture from accumulating
and to maintain drying efficiency, consider exhausting outdoors.
OPTIONAL AIR OUTLET FILTER
The optional air outlet filter (Fig. 6 Page 3) is included as an
IMPORTANT SAFETY INSTRUCTIONS
WARNING - To reduce the risk of fire, electrical shock, or injury to persons when using your appliance, follow basic
precautions, including the following:
•
Read all instructions before using the appliance.
•
Do not wash or dry articles that have been previously
cleaned washed or spotted with gasoline dry cleaning
solvents or other flammable or explosive substances as
they emit vapors that could ignite or explode.
•
Do not allow children to play on or in the appliance.
Close supervision of children is necessary.
•
Before the appliance is removed from service or
discarded remove the door to the washer-dryer
compartment.
•
Do not reach into the appliance if the drum is moving.
•
Do not install or store this appliance where it will be
exposed to the weather
•
Do not tamper with controls.
•
Do not repair or replace any part of the appliance or
attempt any servicing unless specifically recom-
mended in the user-maintenance instructions or in
published user-repair instructions that you understand
and have the skills to carry out.
•
Do not add gasoline dry-cleaning solvents or other
flammable or explosive substances to the wash water.
These substances give off vapors that could ignite or
explode.
•
Under certain conditions, Hydrogen gas may be
produced in a hot water system that has not been
used for 2 weeks or more. HYDROGEN GAS IS
EXPLOSIVE. If the hot water system has not been
used for such a period, before using this combination
washer-dryer, turn on all hot water faucets and let the
water flow from each for several minutes. This will
release any accumulated Hydrogen Gas.
•
Do not use heat to dry articles containing foam rubber
or similar textured rubber-like materials.
•
Keep the exhaust opening and surrounding areas free
from accumulation of lint, dust, and dirt.
•
The interior of the machine should be cleaned periodi-
cally by qualified service personnel.
•
Do not place items exposed to cooking oil in your
dryer. Items contaminated with cooking oils may
contribute to a chemical reaction that could cause a
load to catch fire.
•
Clean dry filter assembly at rear of machine, if
applicable, regularly.
•
Clean drain filter assembly at front of machine
regularly.
Page 4
Sink Drainpipe System:
You should carefully position the drain hose to avoid
kinks and ensure proper drainage of the water. Use a
drain loop or suitable clamp to support drain hose at
25" (62 cm) minimum 34" (86 cm) maximum. The outlet
end of the drain hose must be at least 20" (50 cm) above
the base of the machine. Entry into sink drain system
must be above trap. When routing the drain hose through
cabinets or walls assure no ruff or sharp edges can
damage the drain hose. All sharp edges MUST be
covered by a protective material such as electrical or duct
tape. Use a drain hose clamp to secure drain hose to
"Wye" Branch or Disposer (not included).
•
You may connect directly to a "Wye" Branch Tailpiece
available at most hardware stores.
•
You may connect directly to a Disposer by following
the manufacturer attachment method.
•
You may connect directly through the floor to a
separate trap. The trap must be vented to prevent
siphoning. To provide proper venting; install an Air
Gap Kit available at most hardware stores.
•
You may connect to the manufacturers sink drain kit
(sold separately) that will supply water from your
faucet and discharge water directly into your sink.
Summary of Contents for WD802M
Page 10: ...Page 8 ...
