Page 10
HOW TO USE YOUR NEW WASHER-DRYER
•
Load the drum with clothes as previously described.
Close the door.
•
Select a program. See chart below/11.
•
Select drying time (and half heat if required).
•
Select desired spin speed (high spin only occurs in
regular wash cycle).
•
Put the detergent, bleach and fabric conditioner into
the dispenser.
•
Press the ON-OFF button to start the machine.
Note: Woolen garments should under no circumstances
be tumble dried.
TUMBLE-DRY
If you want to tumble dry a load without washing, rinsing
or spinning, proceed as follows:
Note: The dry weight of the load must not exceed
requirements previously mentioned.
•
Make sure that the power cord is plugged in and that
circuit is energized.
•
Make sure that the wash timer knob is at an OFF-DRY
position.
•
Press the Half Heat button, if you wish to dry at a low
temperature.
•
Set the Dryer Timer knob to the drying time you
require.
•
Open the door, load the articles to be dried into the
cylinder and close the door.
•
Press the On/Off button in and the machine will then
start the drying cycle.
•
Door may be opened during drying cycle.
TO RINSE, SPIN AND TUMBLE-DRY
It is possible to rinse, spin and tumble-dry articles which
have not been previously washed in the machine. The dry
weight of the load must not exceed load size previously
described.
•
Make sure that the power cord is plugged in and that
the circuit is energized.
•
Open the hot and cold water taps fully.
•
Load the machine with the articles to be rinsed.
•
If you wish, put fabric conditioner in the additives
compartment "D" of the Detergent Dispenser (For
WDC1024M compartment “C”).
•
Turn the program selector knob to the position marked
"Rinse". Select the desired heat setting. Press the half
heat if you want a low dry temperature. Set the dryer
timer to the desired time.
•
Select the desired spin speed. High speed spin only
occurs in the regular cycle.
•
Switch the machine on by pressing the ON/OFF
button.
WASHING TABLE
MODELS WDS1043M-SWD1054M-WDC1024-WDC1024M
Summary of Contents for WDC1024M
Page 10: ...Page 8 ...
