Installation and Reference Manual
Configuring PBX functionality
160
Installation and Reference Manual v3.2/0410/6
4
You may wish to change the Description field to assist you with identifying the port
5
In the Presentation Number field enter the number to be presented as outgoing CLI on this port if
required. (Please note that the Translate CLI To field in a Dial Plan entry and a DDI Plan entry will
have priority over the Presentation Number. Please refer to the Outgoing CLI for external calls
section from page 171 for further details.)
6
Enter a DDI Plan in the DDI Call Plan field if required, this determines
a
the plan to be used to route an incoming call received on this Trunk, and
b
the outgoing CLI to be sent with an outgoing call via this Trunk
7
The Capacity field indicates the number of channels available on this Trunk. Amend this value if
additional Trunk licences have been purchased as described below.
8
If required, in the Reserve Incoming Capacity field enter the number of channels to be reserved
solely for incoming calls.
9
Select Update or Apply when ready.
Please note: If a Trunk is not configured with either a DDI Call Plan or a Dial Plan calls on this Trunk will
receive busy.
Trunk Licencing
A Trunk licence (one licence per channel) is required to:
•
activate the channels on the third and fourth BRI ports on the 5100 Call Server
•
activate the channels on the two PRI ports available on the 5100 Call Server
•
activate the channels on the second BRI port on the 5108 Call Server
•
use more than one channel on a PRI trunk on the 4100 Call Server and 4200 Trunk Module.
•
activate the channels on the third and fourth BRI ports on the 4140 Remote Call Server.
•
activate the channels on the 15 channel PRI port available on the 4140 Remote Call Server.
The Capacity field within the configuration form for each of these ports will be set with a default value of
0 channels and must be amended to enable the channels.