Installation and Reference Manual
Configuring PBX functionality
Installation and Reference Manual v3.2/0410/6
165
Please note:
•
No call progress tones are provided
•
When setting up Trunk ports to simulating ISDN into your system in a test environment the call can go
out on any port other than the NT port.
Trunk NT Mode Dongles
For technical data on NT mode dongles please refer to page 341.
Configuring DPNSS
A PRI port provided by a Call Server or Trunk Module can be configured to support DPNSS. No additional
licence is required for this feature other than a Trunk licence to enable a channel on the PRI port. This
implementation of DPNSS will support: Simple Calls, Name, Number, Loop Avoidance, Data Call, and
Node Numbers including Message Waiting and Visual Voice for Index.
Please refer to SpliceCom Support for assistance with configuration of DPNSS.
Creating a H.323 trunk
A Call Server can support H.323 Trunk services and can be configured as follows. Please note that the
required number of Trunk licences (one per channel) must be entered to use this facility (please refer to
page 35 for further details). When using a 4100 Call Server or 4140 Remote Call Server a Voice
Compression Module or card is required to use this facility across the Internet (please refer to page 45 for
further details).
1
In Manager select Modules
2
From the Module list select the Add H323 Gateway button
3
In the Name field enter a name to identify this external gateway
4
Enter the IP address of the remote end.
5
Select Apply
6
Select the Call Server field
7
From the Select Call Server list select the Call Server to which this H.323 Gateway is to be registered.
8
Select Update or Apply when ready.
9
From the navigation pane select Trunks
10
Select the Module created above