Data di emissione:
Dicembre, 2018
Revisione:
1
Pag. :
35/80
Once entered the setting mode i twill be
possible to set the following parameters:
TIME, DAY AND TIME MODE
Once entered the setting mode the first
parameter that it is possible to set is the current
day; i twill be necessary to push the DAY+
button until the right day is shown.
After setting the day it is possible to set the
12h/24h mode by switching from one mode to
the other with the 12h/24h button.
Once selected these two parameters it is
possible to set also the current time, the hours
are now blinking on the display and using the +
and – buttons it is possible to modify it and,
once set, to fix it with the ENTER button.
After fixing the hours the minutes will start
blinking and as for the hours it is possible to
change that value with the + and – buttons and
fix the right setting at the end with the ENTER.
After the minutes confirmation the unit will
automatically switch to the setting of each day
of the week for the automatic functioning.
At this point of the setting procedure only the
first day of the week, Monday (MO) will appear
on the display together with the START one to
underline that it is now possible to set the hours
for the Monday CHILL mode starting time.
The hours are now blinking on the display and it
is possible to modify it with the + and - buttons;
Once the desired hour is set, it is possible to fix
it with the ENTER button.
After fixing the hours it will be possible to fix the
minutes and confirm them in the same way.
After the minute confirmation START will
disappear replaced by STOP in order that it is
now possible to set the end time of the CHILL
mode and the beginning of the FREEZE one.
Once fixed both the hours and the minutes the
day will switch from Monday to Tuesday (TU);
also in this case it will be possible to set the
beginning and the end of the Tuesday CHILL
mode.
In this way it will be possible to set all the days
of the week until the last one, Sunday (SU)
after which the setting procedure will restart
from the beginning with the current time.
With the EXIT button it will be possible to exit
the setting mode.
NOTE: once the week time table has been
set, the unit will automatically maintain it.
NOTE: when the AUTO button is switched
on, the automatic mode parameters are
active and the FREEZE and CHILL buttons
are visible but not functioning.
In order to switch back from the AUTO
mode to the MANUAL one it is necessary to
press the button again.
NOTE: the time table of the automatic
mode is the same for all the three bowls.
NOTE: it is possible to switch on the
FREEZE and the CHILL mode only if at least
one of the three augers is rotating.
Summary of Contents for IPro 1 Slusher ECO
Page 75: ...Data di emissione Dicembre 2018 Revisione 1 Pag 75 80 16 SCHEMA ELETTRICO WIRING DIAGRAM ...
Page 76: ...Data di emissione Dicembre 2018 Revisione 1 Pag 76 80 ...
Page 77: ...Data di emissione Dicembre 2018 Revisione 1 Pag 77 80 ...
Page 78: ...Data di emissione Dicembre 2018 Revisione 1 Pag 78 80 ...
