Data di emissione:
Settembre, 2016
Revisione:
1
Pag. :
32/44
- Empty the bowl of any remaining product.
- After unlocking the main cover with its key,
remove it.
- Fill the bowl with lukewarm water to help melt
off any sugar residuals and drain this water
before proceeding with the next step.
Caution
To avoid electrical shock or contact with
moving parts, before proceeding with the
disassembling operations, make sure all
switches are in “OFF” position and that the
main power supply is disconnected.
- Unscrew and slip off the knobs (fig.11) then
lower the bowl to eliminate any product residue
through the dispensing tap.
- Slightly move up and down the bowl as shown
in figure 12 while pulling it outwards, this
operation will help fully removing it from its
seating.
- Simultaneously apply pressure to the two
securing tabs (Q), and lift the dispensing tap (I)
to pull it out of its fixed position (see figure 13).
- Disassemble the dispensing tap by keeping the
indicated part (R) pressed down and slipping off
the dispensing lever (L) (see figure 14).
- Thoroughly wash each single part with hot
water and mild dish washing detergent, rinse
well, and reassemble the parts.
Caution
To prevent bacteria growth, remove all
o-rings when cleaning.
Failure to do so could create a health
hazard.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Summary of Contents for IPro 2 W
