5. BIOS:
Power on the computer and the system will start POST (Power On Self Test) process. When the message below
appears on the screen, press „
DEL
“ to enter Setup.
To save the BIOS settings press „
F10
“.
Short description of some BIOS settings:
5.1. Wake On RTC:
That allow a computer to 'wake up' after shut down to execute tasks every day or on a
certain day.
-> Power-> RTC
5.2. Restore on AC Power Loss:
This setting specifies whether your system will reboot after a power failure or
interrupt occurs.
-> Power-> Restore on AC Power Loss
[Power Off]
Leaves the computer in the power off state.
[Power ON]
Leaves the computer in the power on state.
[Last State]
Restores the system to the previous status before power failure or interrupt occurred.
5.3. pxe-Boot:
boot an OS via LAN and DHCP.
-> Advanced -> PCI/PCIE Device Configuration -> Launch
OnBoard LAN OpROM
5.4. Wake On LAN:
Wake-on-LAN (WoL) is a particular function that allows the computer to be powered up
from a low-power state by a message from another part of a local area network.
-> Advanced -> PCI/PCIE Device Configuration -> Launch OnChip LAN OpROM
5.5 Modi Serial-Port COM 1:
Advanced -> Super IO Configuration
->
Mode Select
6. Drivers:
The drivers for the spo-book BRICK J1900 can be found in our product catalog on the product page under the
tab "Product Details and Downloads" and on the supplied driver stick.
Direct link:
https://www.spo-comm.de/products/en/brick-j1900-fanless.html
