INSTALLATION
Find a dry, clean, easily accessible, flat surface to mount the SourceLT that
is within reach of the provided battery cables.
Mount the SourceLT using the provided hardware.
Run control cable through the firewall of the cab. Keep protective cap on
during the process.
Connect POSITIVE battery cable to the battery & if the vehicle is 2016 or
newer, chassis ground the sPOD’s negative battery cable. NOTE: This
should not be done before the previous steps!
Use supplied cable ties to secure all cables.
1
2
3
4
5
LOW VOLTAGE CUTOFF
When the red jumper is set on pins 2 & 3 (the two right pins), the LVCO is
turned on. This will help protect your battery from draining due to accessories
being left on for too long. (See Figure A.) When enabled, the system will shut
down when the voltage drops below 11.6 volts after a 2-minute period.
When the red jumper is set on pins 1 & 2 (the two left pins), the LVCO is turned
off. This will not protect your battery from draining due to accessories being
left on for too long. (See Figure B.)
ENABLED
DISABLED
LVCO JUMPER LOCATION
FIGURE B. LVCO DISABLED
FIGURE A. LVCO ENABLED
1 2 3
1 2 3
