| 9
EN | instructioni
4. CONSOLE INSTRUCTION
STEP 3 (see fig D):
• Put the front post (7) into the front post deco-
rative cover (28) first.
• Connect the console wire(14) and spead se-
nor wire(15) together.
• Attach the front post(7) to the main frame (1)
with Screw(63), flat washer(55) and curved
washer(66).
STEP 4 (see fig E):
• Install the console(9) on the front post(7)
with the screws(68).
• Take out the protective plug(82), put the pul-
se sensor wires(19) on the handle bar(8) into
the hole that on the front post (7) and pull it
out. After that, put the protective plug(82)
back into the hole .Fix the handle bar(8) on
the handle bar fixing socket with the T-Shape
knob (51) and decorative part (52) properly.
Be careful not to snag the pulse sensor wire
connected to the handle bar as it will affect
the heart rate measurement.
• Connect hand pulse sensor wires(19) and
main console wires(14) firmly, ensuring a
good connection. Push all excess wires back
down the stem until the console sits on the
bracket.
• When connecting the console to the bracket,
• Insert the saddle support post(4) into the main
frame(1) with the saddle post decorative co-
ver(6) and line up the holes. Secure the saddle
in position with the adjusting knob (10). The
correct height for the saddle can be adjusted
after the bike is fully assembled.
Note:
Do not exceed the mark”stop”.
please note that all the fixings are already
preassembled to the back of the console.
Caution:
Now the equipment is completed assembled,
if you find it not leveled on the floor, you can
adjust it by the adjusting rear stabilizer tube
plug(13). Make sure you have tightened all
the screws and nuts well before beginning
your workout.
4.1 KEY FUNCTIONS:
•
START/STOP:
1. Start & Pauses workouts.
2. Start body fat measurement.
3..Operates only when in stop mode. Holding
key for 3 seconds will reset all function value
to be zero..
•
DOWN:
Decrease value of selected workout
parameter: TIME, DISTANCE, etc. During the
workout, it will decrease the resistance load.
•
UP:
Increases value of selected workout pa-
rameter. During the workout, it will increase
the resistance load.
•
ENTER:
To input desired value or work out
mode.
•
TEST (PULSE, RECOVERY):
Press to enter
into Recovery function when computer has
the heart rate value. Recovery is Fitness Level
1-6 after 1 minute.F1 is the best, and F6 is
the worst.
•
MODE:
Press to switch display form RPM to
SPEED, ODO to DIST , WATT to Calories during
workout.
Summary of Contents for GRADIOR Plus 928657
