11
5. Handlebar Post Installation
Connect the Sensor Wire (64) from the Main Frame (63) to the Middle Section Sensor Wire
(69) from the Handlebar Post (2).
Insert the Handlebar Post (2) into the
Ø
50x
Ø
38 Round Bushing (9) on the tube of the Main
Frame (63) and then attach the Round Knob (15) onto the tube of the Main Frame (63) by
turning it in a clockwise direction to lock the Handlebar Post (2) in the suitable position.
Adjusting the Handlebar Height
Loosen the Round Knob (15) by turning counterclockwise direction until it can be pulled out.
Pull out the Round Knob (15) and then slide the Handlebar Post (2) up or down direction to
the suitable position. Lock the Handlebar Post (2) in place by releasing the Round Knob
(15) and sliding the Handlebar Post (2) up or down slightly until the Round Knob (15) "pops"
down into the locked position. For added safety, tighten the Round Knob (15) in a
clockwise direction.
NOTE: When adjusting the height of handlebar, the STOP line cannot higher than the
edge of round bushing.
