37
FUNCTION BUTTON
• Use this button to select the functions time, speed, distance, calories, and pulse.
Press and hold the button for 2 seconds to reset.
INSERTING THE BATTERIES
1. Remove the battery compartment cover on the back of the monitor.
2. Heeding correct polarity, insert 2 AAA
batteries into the compartment and replace the
cover.
3. If the display can no longer be read or if only some segments are visible, please
remove the batteries and wait 15 seconds before reinserting them. Dispose of empty
batteries properly in accordance with local regulations.
4. The monitor display goes out when the batteries are removed.
FUNCTIONS AND OPERATION
AUTO ON / OFF:
• The monitor turns on automatically when the home trainer is used. The monitor turns
off automatically if you are inactive for a period of
4
minutes.
SCAN:
•
Press the “Mode” button until a triangle next to “Scan” in the upper left-hand corner
of the display appears. The LCD display now shows all functions and values in
succession. Each function is shown for approx. 4 seconds.
TIME:
• Automatically measures the time as soon as training begins.
SPEED:
• Shows the current training speed.
DISTANCE:
• Shows the distance covered during training.
CALORIES:
• Shows the calories consumed during training. This is an approximate value.
PULSE (HEART RATE):
• Automatically registers and shows your current heart rate during training. Press the
button until the arrow points to PULSE. The monitor now shows your current pulse
per minute. To measure your pulse, place both palms on the pulse sensors; the
LCD display shows your current heart rate (pulse beat per minute). Note: The pulse
monitor is intended as a training aid and not as a medical device. If you feel unwell,
please cease training immediately and contact your physician.
SP-HT-1002-IM-V12-INT.indb 37
SP-HT-1002-IM-V12-INT.indb 37
4/16/2021 11:49:27 AM
4/16/2021 11:49:27 AM
