9
11. SECURING YOUR VAULT CONTINUED
TOOLS AND HARDWARE NEEDED TO SECURE
VAULT TO A WOOD OR CONCRETE SURFACE:
WASHERS
PADS
LAG BOLTS
ANCHORS
• DRILL/HAMMER DRILL
• 3/16" DRILL BIT
(FOR WOOD INSTALLATION)
• 1/2” SOCKET WRENCH
• 4 STEEL LAG BOLTS (NOT INCLUDED)
- SIZE 1/4" X 1.50" TO 2.0" LONG
• 4 STEEL WASHERS (NOT INCLUDED)
- 1/4"
• 4 PLASTIC ANCHORS (NOT INCLUDED)
- SIZE #10-12 X 1.5" TO 1.75" LONG
(FOR CONCRETE INSTALLATION)
• 4 PADS (INCLUDED)
Use the recommended hardware or consult your hardware retailer for fastening
hardware for your particular mounting surface.
Open the vault door to provide access to the factory drilled bolt down holes that
are located under the protective foam liner.
To secure your vault to the floor, it will first be necessary to mark and drill pilot
holes in the floor surface.
Drill the appropriate diameter and depth of pilot holes based on the type of
hardware being used and the type of floor surface. We recommend using a hammer
drill and a concrete drill bit to drill the four corresponding holes in the mounting
surface.
Secure the vault by threading anchor bolts through the factory drilled bolt down
holes in the vault and screw down tight with a ratchet wrench.
BOLT
WASHER
VAULT
FLOOR
MOUNTING
SURFACE
ANCHOR
FOR CONCRETE
INSTALLATION
