Contact Customer Service at cs@saproducts.com or (888) 792-4264
8. LOCKED OUT OF YOUR VAULT
In the event you have forgotten the security code you will need to use
your backup keys to gain access to your vault. Follow the E-Lock Security
Setup Code instructions.
If you have lost your backup keys, you will need to contact customer service at the
number below. Proof of purchase is required to obtain keys.
6. LOW BATTERY WARNING
7. SILENT ENTRY MODE
1
2
3
4
Red = Low Battery
7
9. LOCKOUT MODE / TAMPER PROTECTION
By activating the Silent Entry Mode, the
vault will no longer make audible sound.
With your safe open, locate the two
buttons on the inside and top of your
safe. Hold the right button for at least
three seconds until the green light flashes
2 times and the Silent Entry Mode will be
activated. To reactivate sound, hold the
right button for at least three seconds,
until the vault beeps 2 times and the
green light flashes 2 times.
This E-Lock is equipped to alert you when the
batteries are low by illuminating the red light
(center) on the touch pad.
Always test the batteries when installing or replacing.
If the red light comes on when a button is pressed
you know the batteries are not fully charged.
MUTE
1. Three consecutive incorrect code entries will
put the vault in “Basic Lockout” mode. Touch
pad is deactivated for 30 seconds.
2. After “Basic Lockout” mode has ended, another
three consecutive incorrect code entries will result
in “Severe Lockout” mode. Touch pad is deactivated
for 5-minutes.
