5. PROGRAMMING YOUR FINGERPRINT- BIO SCANNER
6
3. Place and hold the pad of your
finger on the scanner until it flashes
green and beeps one time.
4. Repeat at least 3 more times until
there are 2 consecutive beeps and
the indicator ring lights up green.
BEEP
BEEP
BEEP
HOLD FOR BEEP
LIFT FINGER
St
ep 3
St
ep 4
2 BEEPS + GREEN LIGHT = SUCCESS!
St
ep 1
1. Inside of the vault, you will find a
reset button on the right side of
the front panel.
2.
Press the reset button to start the
programming process. You will
hear one beep and the indicator
ring will illuminate on the front of
the door
.
NOTE: Programming mode will time
out after 10 seconds of inactivity. If
this occurs press reset button and
begin again.
St
ep 2
BEEP
THIS SECTION IS TO PROGRAM YOUR FINGERPRINT ON THE BIO SCANNER
THAT OPERATES THE TOP PORTION OF YOUR VAULT.
Battery
Compartment
(4) AA
Reset Button
LED Light
