45
MAINTENANCE
Lubrication Procedure (Continued)
(e) Push in at point A, and slide upward to remove the lubrication hole cover
as (1) (2) shown. (Note that point A provides the best contact surface on
the lubrication hole cover.)
(f) During Banner mode, the message shows “SELECT A PROGRAM”,
press STRIDE ▲ key (B) and STRIDE ▼ key (C) and STOP key (D) at
the same time for 2 seconds to activate this procedure.
(Note the grease fitting at area B.)
(g) Use an automobile grease gun with red lithium grease. Apply the grease
to the nozzle on the product.
(h) Put the cover back into place, pushing inward at (3) and downward at (4)
as shown below. (Note that point A provides the best contact surface on
the lubrication hole cover.)
(h)
(g)
(f)
(e)
