TROUBLE SHOOTING
ERR Messages
Main Fuse Failure
ERR 1- The optical switch mounted on the motor is not receiving the signal reflected
from the tachometer wheel. Please contact your dealer.
ERR 3- Treadmill speed doesn’t match the setting. Contact your local dealer for assistance.
ERR 6- The unit's incline system may be damaged, please contact your dealer for
more information.
ERR 7- The electronics package is receiving the signal reflected from the VR
incorrectly, which means the terminal wires are disconnected, or the VR is
damaged. Please contact your dealer for more information.
ERR 11- The motor is functioning incorrectly. Please contact your dealer for more
information.
ERR 12- The heartrate signal not reflected stably. Please grip the sensor again.
If nothing is displayed on the electronics package, please check the POWER switch
located on the front of the treadmill. If it is ON and unlit, then the fuse may be
damaged and must be replaced.
MAKE SURE THE TREADMILL PLUG IS REMOVED FROM OUTLET
BEFORE REPLACING THE FUSE.
There are two fuse holders located at the front of the treadmill frame, the left 4 amp
fuse holder is for the INCLINE SYSTEM, and the right fuse holder 15 amp/100-120
volts (or 10 amp/ 220-240 volts) is for the Main Power (see Fig.8), please make sure
to check your standard voltage prior to fuse replacement.
CAUTION:
ERR10- Treadmill speed doesn’t match the setting. Contact your local dealer for assistance.
17
FIG.8
100V-120V=15A
200V-240V=10A
