12
STEP 1
Install the Pedestals and Handlebar Assy
(Cont.)
Follow instructions (a through d) below to thread the data cable through the
right pedestal. Before assembly, make sure the left & right pedestals are
align with left and right sides on the main frame.
(a) Pull the cable from the right side of pedestal mount. Cut the zip tie on the
data cable, and pull the cable straight and away from the pedestal mount
as shown. Note: make sure the cable is fully pull out of the oval opening
from the pedestal mount.
(b) Place the right pedestal (A3) on the floor as shown, with the bottom end
facing the data cable. Detach the feeder cord (A4) from the base of the
pedestal and then tie the low end of the feeder cord onto the top of the
data cable.
(c) Disconnect the feeder cord (A4) at the top of the right pedestal (A3). From
the top of the pedestal, pull the feeder cord (A4), thus threading the data
cable through the right pedestal (A3).
(d) Once the data cable has been threaded through the pedestal, untie the
feeder cord (A4) from the data cable.
(c)
(d)
(b)
(a)
