Sports Attsck Junior Hack Attack, Instruction Manual

JUNIOR  HACK  ATTACK

™

 BASEBALL PITCHING MACHINE

SPORTS  ATTACK,  LLC.  

•

  800-717-4251  

•

  sportsattack.com

9

S

hutting Down

SHUTTING DOWN

TURNING JUNIOR HACK ATTACK “OFF”

1.  Set each speed control dial to “0.”

2.  Turn the on/off switch “OFF.”

3.  Unplug Junior Hack Attack from the power source.

PUTTING JUNIOR HACK ATTACK AWAY

1.  Be absolutely sure that the throwing wheels have completely stopped turning.  

2.  See Figure 8A at right:

a.  Turn the elevation adjustment counter-clockwise until the throwing head is all the  

way down.

b.  Push the frame lock pin all the way up (See Figure 8A at right).

c.  Hold the frame lock pin in the up position (See Figure 8B at right).

d.  Turn the elevation adjustment clockwise until the throwing head is held tightly against  

     the frame lock pin. Tighten just enough to secure the throwing head. It is not necessary  
     to over tighten.

  3.  Using the rear leg as a handle, tip Junior Hack Attack up and over onto the wheel guard.  

  4.  Remove (unsocket) both front legs. 

  5.  See Figure 7 below: 
  

Again, using the rear leg as a handle, tip Junior Hack Attack back until machine can  

be comfortably rolled on the travel wheels. Junior Hack Attack can now be rolled and  

maneuvered off of the field.

  6.  To transport Junior Hack Attack in a car, remove the throwing head:
  

a.  Be sure the frame lock is engaged and the throwing head is tightly secured to the yoke.

b.  Completely loosen and remove the horizontal swivel control from the undercarriage  

     nut and place it into the lock storage nut (See Figure 8C). 
  

c.  Lift the throwing head straight up and clear of the undercarriage (See Figure 8D below).

     Suggestion: The throwing head, while awkward, can be carried for short distances by  
     gripping the top section of the wheel guard and balancing the piece against your  
     thighs as you walk.
  

d.  To prevent damage in transport, rest the throwing head on the wheel guard and yoke;  

     motors should be down, and the control panel pointing up.

Figure 8A

Push up frame lock pin

Figure 8B

Hold frame lock all the way up until 

the throwing head is held tightly against the 
frame lock pin.

Figure 8D

Lift the throwing head completely out  

of the undercarriage.

Figure 7

Maneuvering

Figure 8C

 Loosen horizontal swivel lock in  

storage nut.