STEP 3
The Console (22) requires two 1.5 V “AA” batteries
(not included). Remove the battery cover from the
Console and insert two batteries into the battery com-
partment.
Make sure that the batteries are oriented
as shown by the diagram inside the battery com-
partment.
Then, reattach the battery cover.
Have a second person hold the Console (22) near the
Upright (3). Connect the console wire to the Upper
Wire (75). Connect the pulse wire on the console to
the Pulse Wire (74). Insert the excess wire into the
Upright.
Attach the Console (22) to the Upright (3) with four
Console Screws (68).
Be careful to avoid pinching
the wires.
ASSEMBLY INSTRUCTIONS
BDEL2906.0
STEP 4
While another person holds the Upright (3) near the
Frame (1), connect the Upper Wire (75) to the Reed
Switch Wire (67). Next, connect the Resistance
Cable (12) to the Lower Cable (70) in the following
way:
• See drawing A. Pull up on the metal bracket (A)
on the Lower Cable (70), and insert the tip of the
Resistance Cable (12) into the wire clip located
inside the metal bracket.
• See drawing B.
Firmly
pull the Resistance
Cable (12) and slide it into the metal bracket (A)
on the Lower Cable (70) as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket (A)
together.
Slide the Upright (3) onto the Frame (1).
Be careful
to avoid pinching the cables or the wires.
Align the
holes in the Upright with the holes in the Frame.
Attach the Upright with six M8 x 5/8" Hex Bolts (45)
and six M8 Arc Washers (54).
PLEASE DO NOT RETURN TO STORE; CALL OUR CUSTOMER SERVICE DEPARTMENT FIRST AT
1-877-872-6970
9
22
3
68
75
74
Console Wire
Pulse Wire
45
67
54
1
3
12
45
54
54
70
75
45
A
B
C
A
A
A
12
12
70
70
Battery
Compartment
