Page 8
Hardware Required
#17. Bolt (M6x12 mm)
[4 Pieces]
#22. Washer (M6)
[2 Pieces]
#26. Spring Washer (M6)
[4 Pieces]
#28. Arc Washer (M6)
[2 Pieces]
Bolt
Washer
After complete assembly: If the computer is
not picking up your hand pulse signal
(or you
are getting inaccurate readings), Please refer
to our “Troubleshooting” section on
Page 1
1
for
other troubleshoot issues.
HAND PULSE SIGNAL
Troubleshooting
A s s e m b l y S t e p 4
A.) Attach
Handlebar (#04)
to the
Main Frame (#02)
, AND secure them together by using two
Bolts (#17)
,
two
Spring Washers (#26)
and two
Washers (#22)
from the sides, and two
Bolts (#17)
, two
Spring
Washers (#26)
and two
Arc Washers (#28)
from the front.
B.) Connect the
Monitor Wire (Upper) (#45)
to the
Monitor Wire (Lower) (#46)
as shown in the
illustration below.
The assembly process is now complete.
However
, for your own safety, please make sure to read this
entire Owner’s Manual which includes safety instructions and warnings, as well as any safety/warning labels
affixed to the product before use.
For your safety, please visually and functionally inspect and test the unit after assembly is complete.
Assembly Instructions
XRB
358
