SportsArt – 8100 Elliptical Trainer – Incline Calibration Guide
Reassemble the Incline Set (Continued)
9. Reinstall the incline motor as shown in Figure 8.
Test Incline Operation
10. Press display RAMP<
▲
> key until the RAMP window shows 10. The incline should operate to the highest
point.
11. Press the display RAMP<
▼
> key until the RAMP window shows 0. The incline should operate to the
lowest point. (The red line on the thin pipe should show above the end of the thick pipe on the incline motor).
12. During incline operation, inspect whether the drive board ERR LED lights. If the unit has been calibrated
properly but the ERR LED still lights and wires are secure, the VR is malfunctioning. Replace the VR box.
13. If the motor jams or fails to move when there is power to it from the drive board, replace the incline motor set.
Figure 8. Reinstall the motor.
4
