6. Attach the adjust linkage into its place on the rocking bar and secure with the
screw, then cover with the stride adjust cover. (See Fig. 4) Then remove all the
Styrofoam and packing material.
7. Attach the support tubes with the 1/4" x L 3/4" bolts to the upper tube mount. Use
T-handle wrench to secure 5/16" bolts on the lower tube mount. Then cover with
support tube end cap. (See Fig. 5)
Make sure the upper roller is located on the glide rail then fasten the foot pedals
with screws. Secure the lower roller with the shaft and fasten the shaft by open-
end wrench. (See Fig. 5)
Fig.4
Fig.5
PDF created with pdfFactory trial version
