37
OPERATION
User Parameter Setting
Hold the <Change display > for 3 seconds to enter the user parameter
setting procedures; press the <STOP> key at any time to return to the start
screen.
Please refer to the following setting procedures:
(1) Metric System / Imperial Units Setting
The window will display KPH or MPH, press <RESISTANCE
+
/
-
> or
<STRIDE▲/▼> to select the metric system or the imperial units, then
press <ENTER > key to confirm your setting and go to the next step.
(2) Display the Program Version
The window will show the version of each program, press
<RESISTANCE
+
/
-
> or <STRIDE▲/▼>to view each program version,
then press <ENTER > and go to the next step.
Program Version Items:
(a) CTL SA_6 - xx
à
The program version of the control board.
(b) DRV MI - xx - yyyy
à
The program version of the Micro Inverter drive
board.
(c) SA WELL+ x.x.x
à
The program version of the SA WELL+ adapter.
(This function is only available if you purchase SA WELL+.)
(3) Display the Mileage
The window will show the message of DIST- xxxxxx KM or DIST- xxxxxx
MILE, press <ENTER > and go to the next step.
(4) Display the Total Time
The window will show the message “TIME- xxxxxx HOURS”, press
<ENTER > and go to the next step.
(5) Display the Total Watts
The window will show the message of “WATTS- xxxxxx KWH”, press
<ENTER> and go to the next step.