49
MAINTENANCE
Lubrication
To enter Lubrication function, first you must set the console to the
Lubrication state. During Banner mode, the message shows “SELECT
A PROGRAM”, press STRIDE ▲ and STRIDE ▼ and STOP keys at the
same time for 2 seconds to activate this procedure. Once Lubrication
procedure is activated, the stride motor will move to the correct position
and the message will display “LUBRICATION”. At this time, it is ready for
lubrication. Please follow the lubrication procedure listed on the following
page to start lubricating.
Once the lubrication procedure is completed, please follow below
instruction to return the stride length to 29”/730mm.
1. When the power is off, pedaling the elliptical to turn on the power.
2. Press and hold the STOP key for 2 seconds to reset.
The lubrication process is now completed.
MAINTENANCE
Lubrication Procedure
(a) Push in at point A, and slide upward to remove the lubrication cover.
(b) Press the stride up key to adjust the stride to its longest point. Note the
grease fitting at area B.
(c) Use an automobile grease gun with red lithium grease. Apply the
grease to the nozzle on the product.
(d) Put the cover back into place, pushing inward at step 3 and downward
at step 4, as shown below. Note that point A provides the best contact
surface on the lubrication cover.
(a)
(b)
(d)
(c)
2
1
3
4