49
MAINTENANCE
Lubrication System (Continued)
To replace the lubricant bottle, follow instructions (a) through (d) below.
(a) Loosen the screws on the bezel and push the bezel up.
(b) Take the old lubricant bottle out.
(c) Unscrew the nozzle from the old lubricant bottle and screw it onto new
bottle.
(d) Place the new lubricant bottle into the lubrication system; push the
bezel down and tighten it with screws. (Note: Before place the new
bottle in place, press the pump a couple of times to ensure the lubricant
floats through the hose nicely. Pay attention to the lubricant hose
direction when place the bottle into the system.)
Also note the following:
1. Even if the “Lubricant
bottle exchange” warning
is not displaying, it is still
OK to perform the “Lubri-
cant change procedure”.
2. After replacing the lu-
bricant, the total lubrica-
tion timer will reset to 0 and
start counting again.
3. After the “Lubricant
bottle exchange” warning
displayed, the lubrication
system will stop lubricating
automatically. The lubrica-
tion system will continue
lubricating every 1000km
(621.4miles) after the warn-
ing is cleared.
4. The lubrication system will pump twice automatically once the lubricant
exchanging procedure is completed to ensure the new bottle is working
properly.
(a)
(b)
(d)
(c)
