March 2, 2016
6
381-403H WHEELCHAIR SWING
INSTALLATION INSTRUCTION
BEFORE YOU BEGIN
In addition to the components on the packing list you will need a
tape measure, post hole digger, level and a dry erase marker.
INSTALLATION STEPS
__1)
Review all instructions before beginning:
__2)
Unpack, organize, and identify all components:
Be sure to
place all painted components on a protective surface (cardboard,
cloth, etc…) to prevent damage.
__3)
Assemble Swing Frame:
Layout parts so that when frame is
erected, legs will be in approximately correct position. Assemble
swing frame on side, on ground. If more than one section, assemble
section by section.
__4)
Attach Swing End to Legs:
To do this you will need four
1 7/8” x 11’ pipe (2), two swing end fittings (1). Place the swing
legs into the swing end fittings and tighten set screws. See (Detail
A)
__5)
Attaching Middle Post to Swing End:
You will need one
2 3/8” x 4’ pipe (3), two 5/16” x 2 ½” button head bolts (7), two
5/16” x 1” button head nut (8), two 5/16” lock washer (9). Slide the
pipe into the swing end fitting until flush and mark the top and
bottom holes. With a small drill bit drill the marked spots then with
a 7/16” drill bit drill the small holes bigger. Now secure it with
bolt, lock washer and the button head nut. See (Detail B).
