49
BEFORE AND AFTER RUNNING ON THE TREADMILL
Before Running:
1. Read the manual first for familiarisation of the computer and other important features.
2. Before starting the treadmill, always stand on two side rails on both sides (not on the running belt)
as shown on drawing.
3. Have safety key properly placed on the computer console, and have safety clip securely attached
to an article of your clothing.
4. Start the treadmill and allow it to reach at speed of at least 1.0kph, hold your hand on the handle-
bar then walk on the running belt to start your exercise program.
After Running:
1. If you hear any abnormal noise from the motor, please stop using and contact your distributor for
necessary maintenance.
2. Please refer to below RUNNING DECK LUBRICATION to do necessary periodical maintenance for
long-term and functional operation.
PLEASE NOTE WITHOUT DOING PERIODICAL MAINTENANCE THE WARRANTY MIGHT BECO-
ME VOID
RUNNING DECK LUBRICATION
Why to lubricate?
If the lubricant dries out, the friction between the belt and the deck will rise and place undue stress on
the drive motor, drive belt and electronic motor control board, which could result in catastrophic failure
of these expensive components.
When to lubricate?
A high-efficient and low-friction running deck is used on this machine. The deck comes pre-lubricated,
and subsequent lubrication should be done in every 180km, or every 3 months of operation, whiche-
ver comes first. Keeping the deck lubricated at the recommended intervals ensures the longest life
possible for your treadmill.
