EN
35
EMERGENCY STOP
Before beginning a workout session ensure that the Safety Tether Key is properly placed onto the Computer Console
and the Safety Clip is securely attached to an article of your clothing. If you fall the clip will pull out the SAFETY
TETHER KEY from the Computer Console and the running belt will stop immediately for emergency stop, helping to
prevent injury.
Replaced the Safety Tether Key onto the Computer Console. Press the START button to begin exercise again.
Safety Clip
BELT ADJUSTMENT
The running belt is pre-adjusted to the running deck at the factory, but after prolonged use it can stretch and require
readjustment. To increase the tension of the tread, turn on the device and let it run at low speed while using the
supplied tool to make the adjustment. Use the Allen Wrench provided to turn the rear roller adjustment bolts in order
to centre the belt. If the running belt is shifting to the left, turn the left adjustment bolt 1/4 turn clockwise, and the
running belt should start to correct itself.
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn clockwise, and the belt should
start to correct itself. Keep turning the adjustment bolts until the running belt is properly centered.
If the running belt is slipping during use, turn off and unplug the treadmill. Using the Allen Wrench provided, turn
both left and right rear roller adjustment bolts 1/4 turn clockwise, then turn the main power switch back on and run
the treadmill at a speed of 8-10 KPH. Run on to the running belt to determine if the belt is still slipping. Repeat this
procedure until the belt no longer slips.
tool
Allen Wrench
Summary of Contents for F10
