28
4.1 BASE FRAME WITH SUPPORT BARS & COVERS
•
Tighten all individual parts and pre-assembled parts!
•
Check the firmness again before each training session!
4. Assembling
B
B
B
B
A
A
A
A
J D
J
D
J
D
J
D
J
J
J
D
D
D
R
L
J D
A
B
D
J
4 x
4 x
8 x
8 x
Hex
Mul
H
I
C
2 x
If possible, have a second person help you with this step.
•
Hold the right-hand retaining bar
('R')
with the
flat side against the retaining plate at
the bottom of the base frame -
so that all the drill holes in the
retaining bar and retaining plate
match up.
•
Prepare the screw connections:
First slide a washer
('J')
and a spring
washer
('D')
onto each of four long
screws
('A')
and four short screws
('B').
•
Fasten the
retaining
bar with
two long
and two
short screw
connections:
Screw in the screw
connections with a 6 mm
Allen key
(Hex)
.
•
Repeat these three substeps
for the left hand retaining bar
('L').
•
Check the tightness of the screw
connections.
•
Open the knot in the cable which comes out of the right
retaining bar's lower end. Make sure the cable does not slip
into the retaining bar.
•
Join the female connector
('X2')
of the retaining
bar's
('R')
cable with the male connector
('X1')
from the main frame
('CM')
. Make sure they are
locked together.
•
Push the connection and a part of the
protective hose carefully into the retaining
bar's drill hole.
•
Put the covers
('H' and 'I')
on the lower
end of the retaining bars.
•
Fasten the covers with
one cross-head screw
each
('C')
. Use the
multifunction key
('Mul').
H
I
C
C
X1
X2
