15
followed by the Up key for every frequency change instead of having to enter each
frequency manually.
While in the Recall mode the only entries accepted are entries between 1 and 5, the Up or Down
key, the Clear key or the Light key. All other inputs cause the Air-Scan V to beep. Remember,
you may press the Clear key at any time to exit the Recall mode. Once you have left the Recall
mode, the Air-Scan V will remain on the last frequency that was being received.
Memory Scan
The Memory Scan function is very similar to the Search function, except it only scans those
aviation frequencies stored in the memory channels. To scan the memory channels, select the
Aviation band (press the Band key until AIR appears on the screen) then press the Recall key to
enter the Recall mode. Then press and hold the Up or Down key for one second to initiate either
an upward or downward scan. The word SCAN will appear on the top line of the screen and the
memory channel number and frequency will be displayed on the bottom line of the screen.
When a broadcasting signal is found, the Air-Scan
®
V will stop temporarily on that frequency. If
the broadcasting signal is cut off for more than two seconds, the scan will resume until another
signal is found.
The scan may be canceled at any time by pressing the Clear key. The direction of the scan may
also be reversed at any time by pressing and holding the Up or Down key (whichever is
appropriate) for one second.
SCAN
122.975
1
AIR MEM