6
need to be charged.
Press the Key ON/OFF again to close down the instrument when power indicator goes out.
3.3.2 Leveling
Press the Key ON/OFF to bring automatic leveling into function when the laser beam begins to wink.After
automatic leveling, the laser module will rotate right at the speed of 600r.p.m.
If the instrument is placed improperly, or the slope of instrument exceeds the range from -5°to +5°,when mode
indicator and the laser beam will wink at the same time. Then place the instrument properly.
Notice
:
The instrument will close down automatically after five minutes alarm.
3.3.3 Spinning
(1) Continuous spinning
Press the Key Speeding-up to control the spinning speed of the laser module. If press the key repeatedly, the
spinning speed of the laser module will continuously change as follows:0-60-120-300-600-0 r.p.m.
(2) Stepping spinning
Locate the Key Speeding-up at 0 r.p.m, the laser module will stop spinning. And press the Key
Right-spinning, the laser module will step-move clockwise. Then if press the Key Left-spinning, the laser
module will step-move counter-clockwise.
7
3.3.4 Directional scanning
(1) Press the Key Directional scanning; the laser module will scan directionally. If press the key repeatedly,
the angle of scanning of laser module will continuously change as follows: 0°- 10°- 45°- 90°- 180°- 0°.
(2) Press the Key Left-spinning or the Key Right-spinning to change the direction of scanning.
3.3.5 Slope Adjustment
When the instrument is set upright to do horizontal scanning, the slope of X-axis and Y-axis can be adjusted.
Press the Key Manual/Automatic when mode indicator lights, the instrument enters the mode of manual leveling.
(1)
Slope of X-axis
a. Aim the X1-beam to the direction of the slope required to adjust, as depicted below:
