DOM 1000 - DOM 1000 A
DOM 1000 - DOM 1000 A
5
ELECTRICAL CONNECTIONS
The luminaire is designed to operate with a 100V to
240V supply, 50-60Hz, according to the lamp used.
Before and during the installation, make sure you follow
the guidelines below:
• Always check the earth wiring for the line being used.
• Verify that the lamp voltage is correct for the main
voltage
• Do not use lamps other than indicated on the lamp
table
• There are no fuses inside the units, if it is necessary
they should be installed in the mains
• The luminaires can be connected to a dimmer
INSERTING AND CHANGING THE LAMP
- To remove the safety net, insert a screwdriver into the
access point
⑥
and push upwards
- Open the safety net
- Replace the lamp without touching the glass bulb
- Fix the safety net by pushing its frame
⑦
forwards/
down into the locking guide.
Please note that when changing the lamp, the position
of the projector must not necessarily be changed so
that the focus of the projector can stay still.
DESCRIPTION OF THE LUMINAIRE
Referring to images on page 2:
①
Suspension yoke
②
Rear handle
③
Positioning spring
④
Filter-holder
⑤
Safety net
⑥
Access point for safety net opening
⑦
Point for safety net closing and locking
INTRODUCTION
The luminaire you have bought conforms to 73/23/EEC,
93/68/EEC, EN 60598-1 and EN 60598-2-17 directives
and regulations.
The label on the side of the luminaire lists the following
information:
• model
• mains supply voltage (V)
• lamp wattage (W)
• IP protection index
• maximum allowed ambient temperature in °C
• maximum temperature of the body in °C
• minimum distance from flammable surface
• information to find the position 0° of the luminaire:
when the tip of the arrow points upwards
• maximum tilt angle range. These limits, imposed by
the lamp manufacturer, should not be exceeded as
they would reduce the luminaire’s useful life or lead
to its deterioration.
INSTALLATION
• The luminaires are intended for professional use only
so they have to be installed and used by qualified
technicians.
• The products are intended for indoor use:
consequently they have to be protected from humidity
and rain, if used in different conditions (IP 20)
• Do not mount the luminaire on or near a flammable
surface
• Please note carefully the notes written on the labels
of the luminaires.
• Do not forget to connect a safety rope, if required by
local country safety regulations
• For safety requirements the net shall be mounted
on the front of the lamp to prevent any large glass
fragments from falling in case of breaking.
• The projector can be either suspended or placed on a
plane surface.
WARNING: replace immediately the
lamp if visibly damaged, even if still
working.
WARNING: The luminaires must always be
earthed
WARNING: For safety reasons always discon-
nect the projector from the mains before
opening it to change the lamp.
www.liveline.be
