ZuM eco-Set™
9
NOTE:
The additional headset will only remain registered to the base for the duration of
the call. After the primary headset has ended the call, the unit will return to its normal state.
The
ZuM eco-Set™
headset also allows you to make a conference call between your
normal phone and a computer. To activate this option hold down the PC/USB button on
the base for four seconds. The LEDs of the PC/USB and TEL buttons will light. If one of
the buttons is touched again this function will be turned off and the headset will return to
the mode of the button pressed.
3.9 Registering headsets to the base
Up to three headsets can be registered permanently to the base. You can register a new
headset unit to your base using the following procedure.
• Press and hold the 'TEL' or ‘Registration’ button on the headset base for five seconds
to enter the registration mode. The 'TEL' LED will flash to indicate it is now in
registration mode.
• Press and hold the 'Headset ON/OFF' button on the headset for five seconds for the
headset to enter registration mode.
• The headset will now be registered to the base; this will take around 30 seconds.
When the registration has completed, the base ‘TEL’ LED will stop flashing.
The additional 2 auxiliary headsets can be registered using the same procedure but
instead of the ‘TEL’ button, use the microphone ‘Up’ button for headset 2 and the
microphone ‘Down’ button for headset 3. These can be found on the underside of the
headset base.
3.10 Using multiple headsets
If you have more than one headset registered to the base, the first headset to be turned
on becomes the primary headset and takes control of the base. Another headset can
then join and leave the call by the user pressing their headset buttons, but only the
primary headset can end the call.
NOTE:
Only one of the two additional headsets can connect at any one time.
