ZuM eco-Set™
6
2.4 Connecting EHS with DHSG protocols (refer to the unit's User Guide)
• Connect the DHSG cable to your telephone as indicated in its user guide.
• Connect the DHSG cable to the "AUX" and "Tel" ports located on the back of the
headset base.
• Ensure that the EHS selection switch is set to "DHSG".
With the handset lifter or DHSG cable connected, you will be able to answer and end calls
using the button located on the headset while away from your desk.
2.5 Connecting to a computer USB port
• Connect the USB cable supplied with the product to the "USB" port on the back of the
headset base and to an available USB port on your computer.
• The computer should automatically recognize the device and install the correct drivers.
Wait a few seconds before using the
ZuM eco-Set™
headset.
2.6 Replacing the earplugs
To replace the earplug of the
ZuM eco-Set™
over-the ear headset, twist the earplug 90
degrees and pull the earplug towards you.
3. Operation
3.1 Making and Receiving Calls
3.1.1 Making an outgoing call in Telephone mode
• Ensure that the "TEL" button on top of the headset base is selected.
• Lift the headset from the base to start a call. If you are already wearing the headset,
press the headset’s "ON/OFF" button. The base's "Online Indicator" LED will light. If a
handset Lifter or Electronic Hookswitch device is connected to the headset base, the
line will be active and you will hear a dial tone. Otherwise, you will also need to activate
the Headset port via your desktop telephone.
• Dial the telephone number on the telephone's dial pad.
• After finishing the call, replace the headset on the base or press the ON/OFF button to
disconnect. The "Online Indicator" LED will turn off.
