ZuM eco-Set™
7
3. Operation con't
3.1.2 Receive an incoming call in Telephone mode.
• If there is an incoming call from the telephone line and the headset base is
connected to a handset lifter or Electronic Hook Switch device, the "TEL" LED and
"headset" LED will flash; a ring tone will also be heard on the headset.
• Lift the headset from the base to answer the call. If you are already wearing the
headset press the headset’s "ON/OFF" button. The base's "Online Indicator" LED
will light. If a handset Lifter or Electronic Hookswitch device is connected to the
headset base, the line will be active. Otherwise, you will also need to activate the
headset port via your desktop telephone.
• To end the call, replace the headset on the base or press the headset ON/OFF
button.
3.1.3 Making an outgoing call in USB/PC mode
• Ensure that the "PC" button on top of the headset base is selected.
• Lift the headset from the base or press the headset's ON/OFF button if you are
already wearing it, and the base's "Online Indicator" LED will light.
• After finishing your call, press the ON/OFF button to disconnect. The base's
"Online Indicator" LED will turn off.
3.2 Adjusting the Ringer Volume
When the headset is ringing to indicate an incoming call, you can adjust the ring
volume using the volume control buttons located on the headset.
3.3 Muting the Headset Microphone
To mute the headset microphone when on a call, press the 'Mute' button on the headset.
While the headset is in Mute mode, a short beep will be heard on the headset every 8
seconds. Press the 'Mute' button again to release the mute.
3.4 Headset transmitting volume setting
You can adjust the transmit volume of the headset by using the two buttons located on
the bottom of the headset base.
