background image

 

 

 

WARNINGS & PRECAUTIONS 

IMPORTANT: READ ALL INSTRUCTIONS BEFORE USING SPRAY GUN 

THIS IS A HIGH-PRESSURE DEVICE WHICH SHOULD ONLY BE USED IN A 

PROPERLY ENGINEERED SYSTEM. THIS SPRAY GUN SHOULD BE OPERATED ONLY 

BY TRAINED OPERATORS AND KEPT OUT OF REACH OF CHILDREN. PLEASE READ 

THE FOLLOWING INSTRUCTION SHEETS BEFORE ATTEMPTING TO OPERATE THE 

MODEL 60 HIGH PRESSURE GUNJET SPRAY GUN. 

HEED ALL THESE WARNINGS or serious and permanent injury may result. 
GENERAL WARNING FOR HIGH PRESSURE SPRAY GUNS:

 IF THE OPERATING 

PRESSURE IS BETWEEN 100 PSIG (0.69 MPA) AND 3200 PSIG (22.06 MPA), THEN 

AN EXTENSION OR WAND SHOULD BE USED THAT SEPARATES THE DISCHARGE 

NOZZLE A MINIMUM OF 29.5 INCHES (750 MM) FROM THE TRIGGER 

MECHANISM. DO NOT ASSEMBLE DISCHARGE NOZZLE DIRECTLY INTO THE 

SPRAY GUN. 
IF THE OPERATING PRESSURE IS BETWEEN 3200 PSIG (22.06 MPA) AND 5000 

PSIG (34.48 MPA), THEN AN EXTENSION OR WAND SHOULD BE USED THAT 

SEPARATES THE DISCHARGE NOZZLE A MINIMUM OF 4.0 FEET (1.22 M) FROM 

THE TRIGGER MECHANISM. DO NOT ASSEMBLE DISCHARGE NOZZLE DIRECTLY 

INTO THE SPRAY GUN. 
1.

 

DO NOT

 aim gun at any person or any part of the body. Fluids under 

high pressure can penetrate the human skin and can cause severe 

injury, possibly resulting in amputation or death. Hot liquids and 

chemicals can also cause burns or injury. If any part of the body comes 

in contact with the spray stream, immediately consult a physician. 

2.

 

DO NOT

 at any time place hands or any other part of the body in front 

of spray nozzle or tip. 

3.

 

DO NOT

 alter equipment in any manner; if repairs are necessary, use 

only genuine factory repair parts supplied by Spraying Systems Co. 

4.

 

DO NOT

 exceed maximum operating pressure of the lowest rated 

accessory item within the spray system even though some of the 

accessories have a higher maximum pressure rating. 

5.

 

DO NOT

 leave equipment under pressure unattended at any time. 

Relieve pressure by shutting off power to pump, turning off the liquid 

supply to the pump, and actuating Trigger until all fluid ceases to flow; 

then position Trigger Lock to the locked position. 

6.

 

DO NOT

 use damaged, perforated, or weakened fluid hose. 

Summary of Contents for GunJet 30A













Reviews: